R3303-HP HSR6800 Routers Layer 2 - WAN Command Reference

14
Internet protocol processing : disabled
IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 0023-8970-1fd7
IPv6 Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 0023-8970-1fd7
Last clearing of counters: Never
# Display brief information about interface Virtual-Ethernet 1/0/1.
<Sysname> display interface virtual-ethernet 1/0/1 brief
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface Link Protocol Main IP Description
VE1 DOWN DOWN --
# Display brief information about all VE interfaces in down state.
<Sysname> display interface virtual-ethernet brief down
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Interface Link Cause
VE1 DOWN Not connected
Table 8 Command output
Field Descri
p
tion
current state
Physical state of the interface:
• DOWN—The interface is physically down (possibly because no
physical link is present or the link has failed).
• UP—The interface is physically up.
Line protocol current state Link layer state of the interface: UP or DOWN.
Description Interface description.
The Maximum Transmit Unit Maximum transmission unit (MTU) of the interface.
Internet protocol processing
Processing state of the network layer protocol: enabled or
disabled.
IP Packet Frame Type Encapsulation format for IPv4 packets.
Hardware Address MAC address of the interface.
IPv6 Packet Frame Type Encapsulation format for IPv6 packets.
Physical is EoPW
The physical state of the interface is Ethernet over Pseudo Wire
(EoPW). This field is displayed only when you configure the VE
interface to connect an MPLS L2VPN to an MPLS L3VPN.
baudrate
Maximum bandwidth of the interface. This field is displayed only
when you configure the VE interface to enable an MPLS L2VPN to
access an MPLS L3VPN.
Link service is PWE3 ethernet mode
Ethernet mode of the link PWE3. This field is displayed only when
the VE interface is connected to an MPLS L2VPN.
Link service is PWE3 ethernet tagged
mode
VLAN mode of the link PWE3. This field is displayed only when the
VE interface is connected to an MPLS L2VPN.