R3303-HP HSR6800 Routers Layer 2 - WAN Command Reference

15
Field Descri
p
tion
Output queue : (Urgent queue :
Size/Length/Discards)
Output queue : (Protocol queue :
Size/Length/Discards)
Output queue : (FIFO queuing :
Size/Length/Discards)
Packet statistics for the following output queues:
• Urgent queues.
• Protocol queues.
• FIFO queues.
Last clearing of counters: Never
Time when the reset counters interface command was last used to
clear the interface statistics. Never indicates the reset counters
interface command has never been used on the interface after the
device has started up.
Last 300 seconds input: 0 bytes/sec 0
packets/sec
Last 300 seconds output: 0 bytes/sec 0
packets/sec
Average input or output rate over the last 300 seconds in bps and
pps. This field is displayed only when the interface supports traffic
accounting.
0 packets input, 0 bytes, 0 drops
Statistics on the packets received. This field is displayed only when
the interface supports traffic accounting.
0 packets output, 0 bytes, 0 drops
Statistics on the packets sent. This field is displayed only when the
interface supports traffic accounting.
The brief information of interface(s) under
route mode:
Brief information about Layer 3 interfaces.
Link: ADM - administratively down; Stby -
standby
Link layer state of the interface:
• ADM—The interface was shut down by the network
administrator. To recover its physical layer state, perform the
undo shutdown command.
• Stby—The interface is a standby interface. You can use the
display standby state command to check the corresponding
primary interface.
Protocol: (s) - spoofing
If the network layer protocol state of an interface is shown as UP,
but its link is an on-demand link or not present at all, its protocol
attribute includes the spoofing flag (an s in parentheses).
Interface Interface name.
Link
Physical link state of the interface:
• UP—The link is up.
• ADM—The link was administratively shut down. To recover its
physical state, execute the undo shutdown command.
Protocol Protocol connection state of the interface: UP(s).
Main IP Primary IP address.
Description Interface description.
Cause
Cause for a DOWN physical link:
• Administratively—The port was shut down with the shutdown
command. To restore the physical state of the interface, use the
undo shutdown command.
• Not connected—No physical connection exists.