R3303-HP HSR6800 Routers Layer 2 - WAN Command Reference

values from 0 to 31, because they are reserved for special purposes. For more information about the

value range, see Table 3.

mber: Specifies the number of OAM cells to be transmitted consecutively, in the range of 1 to 1000.

The system default is 5.

timeout: Specifies the OAM response timeout period in the range of 1 to 30 seconds. The system default

is 2 seconds.

Examples

# Check the link state of PVC 1/32 on interface ATM 1/0/1, sending three cells and setting timeout

period to 1 second.

<Sysname> system-view

[Sysname] interface atm 1/0/1

[Sysname-Atm1/0/1] oamping interface atm 3/0/1 pvc 1/32 3 1

Ping interface Atm3/0/1,pvc 0/45, with 3 of 53 bytes of ATM OAM F5 end-to-end

cell(s),

timeout is 1 second(s), press CTRL_C to break

Receive reply from pvc 1/32: time=1 ms

pvc

Use pvc to create a PVC or enter the PVC view on ATM interface, or to add the specified PVC into

PVC-Group.

Use undo pvc to delete the specified PVC.

Syntax

pvc { pvc-name [ vpi/vci ] | vpi/vci }

undo pvc { pvc-name [ vpi/vci ] | vpi/vci }

Default

No PVC is created.

Views

ATM interface view, PVC-group view

Default command level

2: System level

Parameters

pvc-name: PVC name, a unique string of 1 to 16 characters on ATM interface, case-insensitive. The name

cannot be the same as a valid VPI/VCI pair value. For example, the name 1/20 is not allowed.

vpi/vci: VPI/VCI pair. VPI is short for virtual path identifier, and its value range is 0 to 255. VCI is short

for virtual channel identifier, and its value range varies by interface type. HP recommends not using VCI

values from 0 to 31, because they are reserved for special purposes. For more information about the

value range, see Table 3.