R3303-HP HSR6800 Routers Layer 2 - WAN Command Reference

28
The maximum number specified in this command is the total number of the PVCs available to both ATM
main interface and the subinterfaces.
This command applies to both ATM main interface and subinterface. However, the command itself is
available only in ATM main interface view.
Examples
# Configure ATM 1/0/1 interface to support up to 1024 PVCs.
<Sysname> system-view
[Sysname] interface atm 1/0/1
[Sysname-Atm1/0/1] pvc max-number 1024
pvp limit
Use pvp limit to set the parameters for VP policing.
Use undo pvp limit to delete the VP policing.
Syntax
pvp limit vpi output-scr
undo pvp limit vpi
Default
VP policing is not performed.
Views
ATM interface view
Default command level
2: System level
Parameters
vpi: Specifies the VPI of the ATM network, in the range of 0 to 255.
output-scr: Specifies the sustainable rate of ATM cell output (in kbps). For more information about the
value range, see Table 10.
Usage guidelines
When applying VP policing, the parameters of PVC are still valid. Only when the parameters of PVC and
VP policing are satisfied, will the packets be transmitted and received. In calculating the traffic, the
LLC/SNAP, MUX and NLPID headers are included, but the ATM cell header is not included.
Examples
# Set the traffic of VP with vpi 1 to 2000 Kbps.
<Sysname> system-view
[Sysname] interface atm 1/0/1
[Sysname-Atm1/0/1] pvp limit 1 2000
Related commands
• pvc
• service cbr
• service vbr-nrt