R3303-HP HSR6800 Routers Layer 2 - WAN Command Reference

37
Views
VT interface view
Default command level
2: System level
Usage guidelines
If extensible PPP accounting is enabled, AAA starts accounting after the PPP user notifies AAA of the peer
IP address obtained in NCP negotiation.
If extensible PPP accounting is disabled, AAA starts accounting after the PPP user starts NCP negotiation.
Examples
# Enable extensible PPP accounting on interface Virtual-Template 1.
<Sysname> system-view
[Sysname] interface Virtual-Template 1
[Sysname-Virtual-Template1] ppp account-statistics extend remote-address
ip pool
Use ip pool to configure an address pool for assigning IP addresses to PPP users.
Use undo ip pool to remove an address pool.
Syntax
ip pool pool-number low-ip-address [ high-ip-address ]
undo ip pool pool-number
Default
No IP address pool is configured for PPP users.
Views
System view, ISP domain view
Default command level
2: System level
Parameters
pool-number: Specifies an address pool by its number in the range of 0 to 99.
low-ip-address: Start address of the address pool.
high-ip-address: End IP address of the address pool. An address pool can contain up to 1024 IP
addresses. If no end IP address is specified, the address pool has only one IP address, the start IP
address.
Usage guidelines
IP address pools configured in system view are for PPP users that do not need authentication. To configure
an IP address pool for the peer PPP users, use the remote address command in a specified interface view.
IP address pools configured in ISP domain view are for PPP users that need authentication in the specified
ISP domain. These IP address pools apply to the interfaces that connect to a larger number of PPP users
than those the interfaces can assign IP addresses for. For example, an Ethernet interface running PPPoE
can accommodate up to 4096 users, but you can configure only one address pool containing up to 1024