R3303-HP HSR6800 Routers Layer 2 - WAN Command Reference

51
Examples
# Set the interval and number of times for sending keepalive packets to 20 seconds and 10, respectively,
on interface Serial 2/0/1.
<Sysname> system-view
[Sysname] interface serial 2/0/1
[Sysname-Serial2/0/1] timer hold 20 10
MP configuration commands
bandwidth
Use bandwidth to set the intended bandwidth for an interface.
Use undo bandwidth to restore the default.
Syntax
bandwidth bandwidth-value
undo bandwidth
Views
VT interface view, MP-group interface view
Default command level
2: System level
Parameters
bandwidth-value: Specifies the intended bandwidth, ranging from 1 to 4294967295 kbps.
Usage guidelines
You can obtain the intended bandwidth of an interface by querying the ifspeed value of the MIB node
with third-party software.
The intended bandwidth is used by the network for bandwidth monitoring. It does not affect the actual
bandwidth of the interface.
Examples
# Set the intended bandwidth to 1000 kbps for interface VT 10.
<Sysname> system-view
[Sysname] interface virtual-template 10
[Sysname-Virtual-Template10] bandwidth 1000
# Set the intended bandwidth to 1000 kbps for interface MP-group 3.
<Sysname> system-view
[Sysname] interface mp-group 3
[Sysname-Mp-group3] bandwidth 1000
broadcast-limit link
Use broadcast-limit link to set the maximum number of links that can be used for transmitting multicast
packets or broadcast packets for the VT.