R3303-HP HSR6800 Routers Layer 2 - WAN Configuration Guide

126
Ste
p
Command Remarks
3. Set the MFR bundle
identifier.
mfr bundle-name [ name ]
Optional.
The default bundle identifier is MFR +
frame relay bundle number, for
example, MFR4/0/0.
You cannot set a bundle identifier in the
MFR number format.
4. Enable MFR
fragmentation.
mfr fragment
Optional.
By default, MRF fragmentation is
disabled.
5. Configure the size of the
MFR sliding window.
mfr window-size number
Optional.
By default, the size of the MFR sliding
window is equal to the number of
physical interfaces bundled by MFR.
6. Configure maximum
fragment size for bundle
link.
mfr fragment-size bytes
Optional.
The default setting is 300 bytes.
7. Enable sub-interface rate
statistics collection for
the MFR interface.
sub-interface rate-statistic
Optional.
By default, this feature is disabled.
With sub-interface rate statistics
collection enabled for an MFR interface,
the system periodically refreshes
sub-interface rate statistics. You can use
the display interface command to view
the collected statistics.
Use this feature cautiously, because it is
system resource demanding.
8. Set the intended
bandwidth for the MFR
interface.
bandwidth bandwidth-value Optional.
9. Configure other
parameters of the MFR
interface.
See "Configuring frame relay."
Optional.
The fr interface-type command and the
fr inarp command are applicable to only
main MFR interfaces.
Configuring an MFR bundle link
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter frame relay interface
view.
interface interface-type
interface-number
N/A
3. Assign the current interface
to an MFR interface.
link-protocol fr mfr
interface-number
By default, an interface is not assigned to
any MFR interface.