R3303-HP HSR6800 Routers Layer 3 - IP Routing Command Reference

129

Default command level

2: System level

Parameters

interface-type interface-number: Specifies an interface by its type and number.

all: Specifies all interfaces.

Usage guidelines

A disabled interface is a passive interface that cannot send any hello packets.

To disable a network from receiving OSPF routes, you can issue this command on the interface

connected to the network.

Examples

# Disable an interface from sending OSPF packets.

<Sysname> system-view

[Sysname] ospf 100

[Sysname-ospf-100] silent-interface GigabitEthernet 2/0/0

snmp-agent trap enable ospf

Use snmp-agent trap enable ospf to enable the sending of SNMP traps for a specified OSPF process. If

no process is specified, the feature is enabled for all processes.

Use undo snmp-agent trap enable ospf to disable the feature.

Syntax

snmp-agent trap enable ospf [ process-id ] [ ifauthfail | ifcfgerror | ifrxbadpkt | ifstatechange |

undo snmp-agent trap enable ospf [ process-id ] [ ifauthfail | ifcfgerror | ifrxbadpkt | ifstatechange |

Default

This feature is enabled.

Views

System view

Default command level

3: Manage level

Parameters

process-id: Specifies an OSPF process by its ID in the range of 1 to 65535.

ifauthfail: Interface authentication failure information.

ifcfgerror: Interface configuration error information.

ifrxbadpkt: Information about error packets received.

ifstatechange: Interface state change information.

iftxretransmit: Packet receiving and forwarding information.