R3303-HP HSR6800 Routers Layer 3 - IP Routing Command Reference

136
[Sysname-isis-1] area-authentication-mode simple ivg
Related commands
• domain-authentication-mode
• isis authentication-mode
• reset isis all
auto-cost enable
Use auto-cost enable to enable automatic link cost calculation.
Use undo auto-cost enable to disable the function.
Syntax
auto-cost enable
undo auto-cost enable
Default
This function is disabled.
Views
IS-IS view
Default command level
2: System level
Usage guidelines
After automatic link cost calculation is enabled, the link cost is automatically calculated based on the
bandwidth reference value of an interface. When the cost-style is wide or wide-compatible, the cost
value of an interface is calculated by using the formula: Cost = (Reference bandwidth value / Link
bandwidth) × 10, which is in the range of 1 to 16777214. For other cost styles, Table 28 a
pplies.
Table 28 Automatic cost calculation scheme for cost styles other than wide and wide-compatible
Interface bandwidth Cost
≤10 Mbps 60
≤100 Mbps 50
≤155 Mbps 40
≤622 Mbps 30
≤2500 Mbps 20
>2500 Mbps 10
Examples
# Enable automatic link cost calculation.
<Sysname> system-view
[Sysname] isis 1
[Sysname-isis-1] auto-cost enable