R3303-HP HSR6800 Routers Layer 3 - IP Routing Command Reference

187
Default command level
2: System level
Parameters
seconds: Specifies on the DIS of a broadcast network the interval for sending CSNP packets. The value
range is 1 to 600 seconds.
level-1: Applies the interval to Level-1.
level-2: Applies the interval to Level-2.
Usage guidelines
This command only applies to the DIS of a broadcast network, which sends CSNP packets periodically
for LSDB synchronization.
If no level is specified, the CSNP interval applies to both Level-1 and Level-2.
Examples
# Configure Level-2 CSNP packets to be sent every 15 seconds over GigabitEthernet 4/0/1.
<Sysname> system-view
[Sysname] interface GigabitEthernet 4/0/1
[Sysname-GigabitEthernet4/0/1] isis timer csnp 15 level-2
isis timer hello
NOTE:
This command is not supported in loopback interface view.
Use isis timer hello to specify the interval for sending hello packets.
Use undo isis timer hello to restore the default.
Syntax
isis timer hello seconds [ level-1 | level-2 ]
undo isis timer hello [ seconds ] [ level-1 | level-2 ]
Default
The default hello interval is 10 seconds.
Views
Interface view
Default command level
2: System level
Parameters
seconds: Specifies the interval for sending hello packets, in the range of 3 to 255 seconds.
level-1: Specifies the interval for sending Level-1 hello packets.
level-2: Specifies the interval for sending Level-2 hello packets.