R3303-HP HSR6800 Routers Layer 3 - IP Routing Command Reference

197
Default command level
2: System level
Parameters
topology-name: Specifies a topology by its name, a case-sensitive string of 1 to 31 characters.
topology-number: Specifies a topology by its number in the range of 6 to 4095.
Usage guidelines
This command takes effect only after you enable the IPv4 unicast topology for the IPv4 address family
and set the cost style to wide, compatible, or wide-compatible for the system.
Examples
# Enable IPv4 unicast topology voice (4000) for IS-IS process 1.
<Sysname> system-view
[Sysname] isis 1
[Sysname-isis-1] multiple-topology ipv4-unicast voice 4000
network-entity
Use network-entity to configure the Network Entity Title for an IS-IS routing process.
Use undo network-entity to delete a NET.
Syntax
network-entity net
undo network-entity net
Default
No NET is configured.
Views
IS-IS view
Default command level
2: System level
Parameters
net: Network Entity Title (NET) in the format of X…X.XXXX....XXXX.00 in hexadecimal notation, with the
first part X…X being the area address, the middle part XXXX....XXXX (a total of 12 "X") being the router's
system ID, and the last part 00 being SEL.
Usage guidelines
A NET is a special NSAP address with the SEL being 0. The length of the NET is in the range of 8 bytes
to 20 bytes.
A NET comprises the following parts:
• Area ID—Its length is in the range of 1 to 13 bytes.
• System ID—A system ID uniquely identifies a host or router in the area and has a fixed 6-byte
length.
• SEL—It has a value of 0 and a fixed 1-byte length.