R3303-HP HSR6800 Routers Layer 3 - IP Routing Command Reference

281
undo peer { group-name | ip-address } route-policy route-policy-name { export | import }
Default
No routing policy is applied to routes from/to the peer/peer group.
Views
BGP view, BGP-VPN instance view
Default command level
2: System level
Parameters
group-name: Specifies the name of a peer group, a string of 1 to 47 characters.
ip-address: Specifies the IP address of a peer.
route-policy-name: Specifies the routing policy name, a case-sensitive string of 1 to 63 characters.
export: Applies the routing policy to routes outgoing to the peer (or peer group).
import: Applies the routing policy to routes incoming from the peer (or peer group).
Usage guidelines
The peer route-policy command does not apply the if-match interface clause in the referenced routing
policy. For related commands, see "Routing policy configuration commands".
Examples
# In BGP view, apply routing policy test-policy to routes outgoing to the peer group test.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] peer test route-policy test-policy export
# In BGP-VPN instance view, apply the routing policy test-policy to routes outgoing to the peer group test.
(The VPN has been created.)
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv4-family vpn-instance vpn1
[Sysname-bgp-ipv4-vpn1] peer test route-policy test-policy export
peer route-update-interval (BGP/BGP-VPN instance view)
Use peer route-update-interval to specify the interval for sending the same update to a peer or peer
group.
Use undo peer route-update-interval to restore the default value.
Syntax
peer { group-name | ip-address } route-update-interval interval
undo peer { group-name | ip-address } route-update-interval
Default
The interval is 15 seconds for IBGP peers, and 30 seconds for EBGP peers.
Views
BGP view, BGP-VPN instance view