R3303-HP HSR6800 Routers Layer 3 - IP Routing Command Reference

395
Syntax
ipv6 preference { preference | route-policy route-policy-name } *
undo ipv6 preference
Default
The default preference for IPv6 IS-IS protocol is 15.
Views
IS-IS view
Default command level
2: System level
Parameters
preference: Specifies a preference for IPv6 IS-IS, in the range of 1 to 255.
route-policy-name: Specifies a routing policy by its name, a case-sensitive string of 1 to 63 characters.
Usage guidelines
When a router runs multiple dynamic routing protocols, the system assigns a preference to each routing
protocol. If several protocols find routes to the same destination, the route found by the protocol with the
highest preference is selected.
Examples
# Configure the preference of IPv6 IS-IS as 20.
<Sysname> system-view
[Sysname] isis 1
[Sysname-isis-1] ipv6 preference 20
ipv6 summary
Use ipv6 summary to configure an IPv6 IS-IS summary route.
Use undo ipv6 summary to remove the summary route.
Syntax
ipv6 summary ipv6-prefix prefix-length [ avoid-feedback | generate_null0_route | [ level-1 | level-1-2 |
level-2 ] | tag tag ] *
undo ipv6 summary ipv6-prefix prefix-length [ level-1 | level-1-2 | level-2 ]
Default
Route summarization is disabled.
Views
IS-IS view
Default command level
2: System level
Parameters
ipv6-prefix: Specifies an IPv6 prefix of the summary route.
prefix-length: Specifies the length of the IPv6 prefix, in the range of 0 to 128.