R3303-HP HSR6800 Routers Layer 3 - IP Routing Command Reference

473
apply ipv6-address next-hop
Use apply ipv6-address next-hop to set a next hop.
Use undo apply ipv6-address next-hop to remove the next hop.
Syntax
apply ipv6-address next-hop ipv6-address
undo apply ipv6-address next-hop [ ipv6-address ]
Views
IPv6 policy node view
Default command level
2: System level
Parameters
ipv6-address: Specifies the next-hop IPv6 address.
Usage guidelines
The next hop must be adjacent to the device.
You can specify up to five next hops for per-flow load balancing.
With a next hop specified, the undo apply ipv6-address next-hop command removes the specified next
hop.
With no next hop specified, the undo apply ipv6-address next-hop command removes all next hops.
Examples
# Set a next hop of 1::1 for IPv6 packets.
<Sysname> system-view
[Sysname] ipv6 policy-based-route aa permit node 11
[Sysname-pbr6-aa-11] apply ipv6-address next-hop 1::1
apply ipv6-precedence
Use apply ipv6-precedence to set a preference or preference type for IPv6 packets.
Use undo apply ipv6-precedence to remove the configuration.
Syntax
apply ipv6-precedence { type | value }
undo apply ipv6-precedence
Views
IPv6 policy node view
Default command level
2: System level
Parameters
type: Sets a preference type.