R3303-HP HSR6800 Routers Layer 3 - IP Routing Command Reference

493
apply preferred-value
Use apply preferred-value to set a preferred value for BGP routes.
Use undo apply preferred-value to remove the clause configuration.
Syntax
apply preferred-value preferred-value
undo apply preferred-value
Default
No preferred value is set for BGP routes.
Views
Routing policy view
Default command level
2: System level
Parameters
preferred-value: Specifies a preferred value in the range of 0 to 65535.
Examples
# Configure node 10 in permit mode of routing policy policy1. Set a preferred value of 66 for BGP
routing information matching AS path list 1.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match as-path 1
[Sysname-route-policy] apply preferred-value 66
apply qos-local-id
Use apply qos-local-id to set a QoS-local ID for matching routes.
Use undo apply qos-local-id to remove the configuration.
Syntax
apply qos-local-id local-id-value
undo apply qos-local-id
Default
No QoS-local ID is set for matching routes.
Views
Routing policy view
Default command level
2: System level
Parameters
local-id-value: Specifies a QoS-local ID in the range of 1 to 4095.