R3303-HP HSR6800 Routers Layer 3 - IP Routing Command Reference

521
multiple-topology enable
Use multiple-topology enable to enable a topology on the interface.
Use undo multiple-topology enable to remove the configuration.
Syntax
multiple-topology topology-name enable
undo multiple-topology topology-name enable
Default
The interface is not enabled with any topology.
Views
Interface view
Default command level
2: System level
Parameters
topology-name: Specifies a topology by its name, a case-sensitive string of 1 to 31 characters.
Examples
# Enable topology voice on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEtherne1/0/1] multiple-topology voice enable
routing-table limit
Use routing-table limit to configure the maximum number of routes supported by the topology.
Use undo routing-table limit to restore the default.
Syntax
routing-table limit number { warn-threshold | simply-alert }
undo routing-table limit
Default
The maximum number of routes supported by the topology depends on the device model.
Views
Topology view
Default command level
2: System level
Parameters
number: Specifies the maximum number of routes supported by the topology. The value range for the
number argument is 1 to 1000100.