R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

103
After the area where Router C resides is configured as a stub area, a default route replaces the AS
external route.
# Configure the area as a totally stub area by filtering Type-3 LSAs out of the Stub area.
[RouterA] ospf
[RouterA-ospf-1] area 1
[RouterA-ospf-1-area-0.0.0.1] stub no-summary
[RouterA-ospf-1-area-0.0.0.1] quit
# Display OSPF routing information on Router C.
[RouterC] display ospf routing
OSPF Process 1 with Router ID 10.4.1.1
Routing Tables
Routing for Network
Destination Cost Type NextHop AdvRouter Area
0.0.0.0/0 4 Inter 10.2.1.1 10.2.1.1 0.0.0.1
10.2.1.0/24 3 Transit 10.2.1.2 10.4.1.1 0.0.0.1
10.4.1.0/24 3 Stub 10.4.1.1 10.4.1.1 0.0.0.1
Total Nets: 3
Intra Area: 2 Inter Area: 1 ASE: 0 NSSA: 0
The output shows that inter-area routes are removed, and only one external route (a default route)
exists.
Configuring an OSPF NSSA area
Network requirements
• Configure OSPF on all routers and split AS into three areas.
• Configure Router A and Router B as ABRs to forward routing information between areas.
• Configure Area 1 as an NSSA area and configure Router C as an ASBR to redistribute static routes
into the AS.
Figure 26 Network diagram
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown.)