R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

139
• RFC 2973, IS-IS Mesh Groups
• RFC 3277, IS-IS Transient Blackhole Avoidance
• RFC 3358, Optional Checksums in ISIS
• RFC 3373, Three-Way Handshake for IS-IS Point-to-Point Adjacencies
• RFC 3567, Intermediate System to Intermediate System (IS-IS) Cryptographic Authentication
• RFC 3719, Recommendations for Interoperable Networks using IS-IS
• RFC 3786, Extending the Number of IS-IS LSP Fragments Beyond the 256 Limit
• RFC 3787, Recommendations for Interoperable IP Networks using IS-IS
• RFC 3784, IS-IS extensions for Traffic Engineering
• RFC 3847, Restart signaling for IS-IS
IS-IS configuration task list
Task Remarks
Configuring IS-IS
basic functions
Enabling IS-IS
Required. Configuring the IS level and circuit level
Configuring the network type of an interface as P2P
Configuring IS-IS
routing information
control
Configuring IS-IS link cost Optional.
Specifying a priority for IS-IS Required.
Configuring the maximum number of ECMP routes Optional.
Configuring IS-IS route summarization Optional.
Advertising a default route Optional.
Configuring IS-IS route redistribution Optional.
Configuring IS-IS route filtering Optional.
Configuring IS-IS route leaking Optional.
Configuring a DIS
priority for an
interface
Specifying intervals for sending IS-IS hello and CSNP packets Optional.
Specifying the IS-IS hello multiplier Optional.
Configuring a DIS priority for an interface Optional.
Disabling an interface from sending/receiving IS-IS packets Optional.
Disabling hello source address check for a PPP interface Optional.
Enabling an interface to send small hello packets Optional.
Configuring LSP parameters Optional.
Configuring SPF parameters Optional.
Assigning a high priority to IS-IS routes Optional.
Setting the LSDB overload bit Optional.
Configuring system ID to host name mappings Optional.
Enabling the logging of neighbor state changes Optional.