R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

140
Task Remarks
Enhancing IS-IS
network security
Configuring neighbor relations
hip authentication Optional.
Configuring area authentication Optional.
Configuring routing domain authentication Optional.
Configuring IS-IS GR Optional.
Configuring IS-IS NSR Optional.
Configuring IS-IS FRR Optional.
Enabling IS-IS SNMP trap Optional.
Binding an IS-IS process with MIBs Optional.
Configuring BFD for IS-IS Optional.
Configuring IS-IS MTR Optional.
Configuring IS-IS basic functions
This section describes the basic settings required for an IS-IS network to run.
Configuration prerequisites
Before the configuration, complete the following tasks:
• Configure the link layer protocol.
• Configure IP addresses for all interfaces, and make sure that all neighboring nodes are reachable
to each other at the network layer.
Enabling IS-IS
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable the IS-IS routing
process and enter its view.
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
Not enabled by default.
3. Assign a network entity title.
network-entity net Not assigned by default.
4. Return to system view.
quit N/A
5. Enter interface view.
interface interface-type
interface-number
N/A
6. Enable an IS-IS process on the
interface.
isis enable [ process-id ] Disabled by default.
Configuring the IS level and circuit level
If only one area exists, perform the following operations: