R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

205
Task Remarks
Forbidding session establishment with a peer or
peer group
Optional.
Configuring GTSM for BGP Optional.
Disabling BGP route advertisement to a peer or
peer group
Optional.
Configuring BGP soft-reset Optional.
Disabling BGP routing policies from automatically
taking effect
Optional.
Configuring a large scale
BGP network
Configuring BGP community Optional.
Configuring a BGP route reflector Optional.
Configuring a BGP confederation Optional.
Configuring BGP GR Optional.
Configuring BGP NSR Optional.
Enabling trap Optional.
Enabling logging of session state changes Optional.
Configuring BFD for BGP Optional.
Configuring basic BGP
This section describes the tasks required for a BGP network to work.
Enabling BGP
A router ID is the unique identifier of a BGP router in an AS.
• To ensure the uniqueness of a router ID and enhance availability, you can specify in BGP view the
IP address of a local loopback interface as the router ID.
• If no router ID is specified in BGP view, the global router ID is used.
• If the global router ID is used and then the interface that owns the router ID is removed, the router
selects a new router ID.
• If you specify a router ID in BGP view and then remove the interface that owns the router ID, the
router does not select a new router ID. To select a new router ID, use the undo router-id command
in BGP view.
To enable BGP:
Step Command Remarks
1. Enter system view.
system-view N/A