R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

218
Figure 68 IBGP and IGP synchronization
For this example, if synchronization is enabled, and the route 8.0.0.0/24 received from Router B is
available in its IGP routing table, Router D advertises the IBGP route when the following conditions are
met:
• The next hop of the route is reachable.
• An active route with the same destination network segment is available in the IGP routing table (use
the display ip routing-table protocol command to check the IGP route state).
You can disable the synchronization feature in the following situations:
• The local AS is not a transitive AS (AS 20 is a transitive AS in the above figure).
• Routers in the local AS are IBGP fully meshed.
To enable BGP and IGP synchronization:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enable synchronization
between BGP and IGP.
synchronization Not enabled by default.
Limiting prefixes received from a peer or peer group
This feature can prevent that send a large number of BGP routes to the router.
If the number of routes received from a peer or peer group exceeds the upper limit, the router takes one
of the following actions based on your configuration:
• Tear down the BGP session to the peer or peer group.
• Display an alarm message.
• Tear down the BGP session to the peer or peer group and, after a specified period of time,
reestablishes a BGP session to the peer or peer group.
You can specify the threshold value for the router to display an alarm message. When the ratio of the
number of received routes to the maximum number reaches the percentage value, the router displays an
alarm message.
To configure the maximum number of prefixes allowed to be received from a peer or peer group: