R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

271
[RouterC-GigabitEthernet2/1] return
6. Verify the configuration:
The following operations are made on Router C. Operations on Router A are similar.
# Display detailed BFD session information.
<RouterC> display bfd session verbose
Total Session Num: 1 Init Mode: Active
IP Session Working Under Ctrl Mode:
Local Discr: 17 Remote Discr: 13
Source IP: 3.0.2.2 Destination IP: 3.0.1.1
Session State: Up Interface: GigabitEthernet2/1/1
Min Trans Inter: 500ms Act Trans Inter: 500ms
Min Recv Inter: 500ms Act Detect Inter: 3500ms
Recv Pkt Num: 57 Send Pkt Num: 53
Hold Time: 2200ms Connect Type: Indirect
Running Up for: 00:00:06 Auth mode: Simple
Protocol: BGP
Diag Info: No Diagnostic
The output shows that a BFD session is established between GigabitEthernet 2/1/2 of Router A
and GigabitEthernet 2/1/1 of Router C and that BFD runs correctly.
# Display BGP peer information on Router C, and you can see that Router C has established two
BGP neighborships with Router A.
<RouterC> display bgp peer
BGP local router ID : 1.1.1.1
Local AS number : 200
Total number of peers : 2 Peers in established state : 2
Peer AS MsgRcvd MsgSent OutQ PrefRcv Up/Down State
2.0.1.1 200 7 10 0 0 00:01:05 Established
3.0.1.1 200 7 10 0 0 00:01:34 Established
# Display route 1.1.1.0/24 on Router C, and you can see that Router A and Router C
communicate through Router B.
<RouterC> display ip routing-table 1.1.1.0 24 verbose
Routing Table : Public
Summary Count : 2
Destination: 1.1.1.0/24
Protocol: BGP Process ID: 0
Preference: 0 Cost: 50
NextHop: 3.0.1.1 Interface: GigabitEthernet2/1/1
BkNextHop: 0.0.0.0 BkInterface:
RelyNextHop: 3.0.2.1 Neighbor : 3.0.1.1
Tunnel ID: 0x0 Label: NULL