R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

Router C GE2/1/1 10.1.1.100

Router D

GE2/1/1 12.1.1.2/24

GE2/1/2 13.1.1.2/24 GE2/1/2 11.1.1.1/24

Configuration procedure

1. Configure IP addresses for the interfaces. (Details not shown.)

2. Configure static routes and BFD:

# Configure static routes on Router A and enable BFD control packet mode for the static route

through Router D.

<RouterA> system-view

[RouterA] interface loopback 1

[RouterA-LoopBack1] bfd min-transmit-interval 500

[RouterA-LoopBack1] bfd min-receive-interval 500

[RouterA-LoopBack1] bfd detect-multiplier 9

[RouterA-LoopBack1] quit

[RouterA] ip route-static 120.1.1.0 24 2.2.2.9 bfd control-packet bfd-source 1.1.1.9

[RouterA] ip route-static 120.1.1.0 24 GigabitEthernet 2/1/2 10.1.1.100 preference

[RouterA] quit

# Configure static routes on Router B and enable BFD control packet mode for the static route

through Router D.

<RouterB> system-view

[RouterB] interface loopback 1

[RouterB-LoopBack1] bfd min-transmit-interval 500

[RouterB-LoopBack1] bfd min-receive-interval 500

[RouterB-LoopBack1] bfd detect-multiplier 9

[RouterB-LoopBack1] quit

[RouterB] ip route-static 121.1.1.0 24 1.1.1.9 bfd control-packet bfd-source 2.2.2.9

[RouterB] ip route-static 121.1.1.0 24 GigabitEthernet 2/1/2 13.1.1.2 preference 65

[RouterB] quit

# Configure static routes on Router C.

<RouterC> system-view

[RouterC] ip route-static 120.1.1.0 24 GigabitEthernet 2/1/2 13.1.1.1

[RouterC] ip route-static 121.1.1.0 24 GigabitEthernet 2/1/1 10.1.1.102

# Configure static routes on Router D.

<RouterD> system-view

[RouterD] ip route-static 120.1.1.0 24 GigabitEthernet 2/1/2 11.1.1.2

[RouterD] ip route-static 121.1.1.0 24 GigabitEthernet 2/1/1 12.1.1.1

3. Verify the configuration:

The following operations are performed on Router A. The operations on Router B are similar.

# Display the BFD session information.

<RouterA> display bfd session

Total Session Num: 1 Init Mode: Active

Session Working Under Ctrl Mode: