R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

17
LD/RD SourceAddr DestAddr State Holdtime Interface
4/7 1.1.1.9 2.2.2.9 Up 2000ms Loop1
# Display the static route information on Router A.
<RouterA> display ip routing-table protocol static
Public Routing Table : Static
Summary Count : 2
Static Routing table Status : <Active>
Summary Count : 1
Destination/Mask Proto Pre Cost NextHop Interface
120.1.1.0/24 Static 60 0 2.2.2.9 GE2/1/1
Static Routing table Status : <Inactive>
Summary Count : 1
Destination/Mask Proto Pre Cost NextHop Interface
120.1.1.0/24 Static 65 0 10.1.1.100 GE2/1/2
# Enable BFD debugging. When the link between Router A and Router D fails, Router A can detect
the failure.
<RouterA> debugging bfd event
<RouterA> debugging bfd scm
<RouterA> terminal debugging
%Oct 10 10:18:18:672 2010 RouterA BFD/4/LOG:Sess[1.1.1.9/2.2.2.9, Loop1,Ctrl], Sta:
UP->DOWN, Diag: 1
*Oct 10 10:18:18:672 2010 RouterA BFD/7/EVENT:Send sess-down Msg,
[Src:1.1.1.9,Dst:2.2.2.9,Loop1,Ctrl], instance:0, protocol:STATIC
# Display the static route information again. Router A communicates with Router B over the static
route passing Router C now.
<RouterA> display ip routing-table protocol static
Public Routing Table : Static
Summary Count : 2
Static Routing table Status : <Active>
Summary Count : 1
Destination/Mask Proto Pre Cost NextHop Interface
120.1.1.0/24 Static 65 0 10.1.1.100 GE2/1/2
Static Routing table Status : <Inactive>
Summary Count : 1
Destination/Mask Proto Pre Cost NextHop Interface
120.1.1.0/24 Static 60 0 2.2.2.9