R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

287

<RouterA> terminal debugging

<RouterA> terminal monitor

# Ping Loopback 0 of Router B from Host A, and set the data length to 80 bytes.

C:\>ping -l 80 10.1.1.1

Pinging 10.1.1.1 with 80 bytes of data:

Reply from 10.1.1.1: bytes=80 time<1ms TTL=255

Ping statistics for 10.1.1.1:

Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),

Approximate round trip times in milli-seconds:

Minimum = 0ms, Maximum = 0ms, Average = 0ms

The debugging information about PBR displayed on Router A is as follows:

*Jun 7 12:04:33:519 2009 RouterA PBR/7/POLICY-ROUTING: IP policy based routing

success : POLICY_ROUTEMAP : lab1, Node : 10, next-hop : 150.1.1.2

*Jun 7 12:04:34:518 2009 RouterA PBR/7/POLICY-ROUTING: IP policy based routing

success : POLICY_ROUTEMAP : lab1, Node : 10, next-hop : 150.1.1.2

*Jun 7 12:04:35:518 2009 RouterA PBR/7/POLICY-ROUTING: IP policy based routing

success : POLICY_ROUTEMAP : lab1, Node : 10, next-hop : 150.1.1.2

*Jun 7 12:04:36:518 2009 RouterA PBR/7/POLICY-ROUTING: IP policy based routing

success : POLICY_ROUTEMAP : lab1, Node : 10, next-hop : 150.1.1.2

The preceding information shows that Router A sets the next hop for the received packets to

150.1.1.2 according to PBR. The packets are forwarded through Serial 2/2/0.

# Ping Loopback 0 of Router B from Host A, and set the data length to 200 bytes.

C:\>ping -l 200 10.1.1.1

Pinging 10.1.1.1 with 200 bytes of data:

Reply from 10.1.1.1: bytes=200 time<1ms TTL=255

Ping statistics for 10.1.1.1:

Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),

Approximate round trip times in milli-seconds:

Minimum = 0ms, Maximum = 0ms, Average = 0ms

The debugging information about PBR displayed on Router A is as follows:

*Jun 7 12:06:47:631 2009 RouterA PBR/7/POLICY-ROUTING: IP policy based routing

success : POLICY_ROUTEMAP : lab1, Node : 20, next-hop : 151.1.1.2

*Jun 7 12:06:48:630 2009 RouterA PBR/7/POLICY-ROUTING: IP policy based routing