R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

298
RIPng packet processing procedure
Request packet
When a RIPng router first starts or must update entries in its routing table, it usually sends a multicast
request packet to ask for needed routes from neighbors.
The receiving RIPng router processes RTEs in the request. If only one RTE exists with the IPv6 prefix and
prefix length both being 0 and with a metric value of 16, the RIPng router responds with the entire routing
table information in response messages. If multiple RTEs exist in the request message, the RIPng router
examines each RTE, update its metric, and send the requested routing information to the requesting router
in the response packet.
Response packet
The response packet containing the local routing table information is generated as follows:
• A response to a request
• An update periodically
• A trigged update caused by route change
After receiving a response, a router checks the validity of the response before adding the route to its
routing table, such as whether the source IPv6 address is the link-local address and whether the port
number is correct. The response packet that failed the check is discarded.
Protocols and standards
• RFC 2080, RIPng for IPv6
• RFC 2081, RIPng Protocol Applicability Statement
RIPng configuration task list
Task Remarks
Configuring RIPng basic functions Required.
Configuring RIPng route control
Configuring an additional routing metric Optional.
Configuring RIPng route summarization Optional.
Advertising a default route Optional.
Configuring a RIPng route filtering policy Optional.
Configuring a priority for RIPng Optional.
Configuring RIPng route redistribution Optional.
Tuning and optimizing the RIPng
network
Configuring RIPng timers Optional.
Configuring split horizon and poison reverse Optional.
Configuring zero field check on RIPng packets Optional.
Configuring the maximum number of ECMP routes Optional.
Applying IPsec policies for RIPng Optional.