R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

300
Configuring an additional routing metric
An additional routing metric can be added to the metric of an inbound or outbound RIPng route.
The outbound additional metric is added to the metric of a sent route. The route's metric in the routing
table is not changed.
The inbound additional metric is added to the metric of a received route before the route is added into
the routing table, so the route's metric is changed.
To configure an inbound or outbound additional routing metric:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type interface-number N/A
3. Specify an inbound routing
additional metric.
ripng metricin value
Optional.
0 by default.
4. Specify an outbound
routing additional metric.
ripng metricout value
Optional.
1 by default.
Configuring RIPng route summarization
Ste
p
Command
1. Enter system view.
system-view
2. Enter interface view.
interface interface-type interface-number
3. Advertise a summary IPv6 prefix.
ripng summary-address ipv6-address prefix-length
Advertising a default route
With this feature enabled, a default route is advertised through the specified interface regardless of
whether the default route is available in the local IPv6 routing table.
To advertise a default route:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Advertise a default route.
ripng default-route { only |
originate } [ cost cost ]
Not advertised by default.