R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

306
[RouterA] interface gigabitethernet 2/1/2
[RouterA-Gigabitethernet2/1/2] ripng 1 enable
[RouterA-Gigabitethernet2/1/2] quit
# Configure Router B.
<RouterB> system-view
[RouterB] ripng 1
[RouterB-ripng-1] quit
[RouterB] interface gigabitethernet 2/1/1
[RouterB-Gigabitethernet2/1/1] ripng 1 enable
[RouterB-Gigabitethernet2/1/1] quit
[RouterB] interface gigabitethernet 2/1/2
[RouterB-Gigabitethernet2/1/2] ripng 1 enable
[RouterB-Gigabitethernet2/1/2] quit
# Configure Router C.
<RouterC> system-view
[RouterC] ripng 1
[RouterC-ripng-1] quit
[RouterC] interface gigabitethernet 2/1/1
[RouterC-Gigabitethernet2/1/1] ripng 1 enable
[RouterC-Gigabitethernet2/1/1] quit
[RouterC] interface gigabitethernet 2/1/2
[RouterC-Gigabitethernet2/1/2] ripng 1 enable
[RouterC-Gigabitethernet2/1/2] quit
[RouterC] interface gigabitethernet 2/1/3
[RouterC-Gigabitethernet2/1/3] ripng 1 enable
[RouterC-Gigabitethernet2/1/3] quit
# Display the routing table of Router B.
[RouterB] display ripng 1 route
Route Flags: A - Aging, S - Suppressed, G - Garbage-collect
----------------------------------------------------------------
Peer FE80::20F:E2FF:FE23:82F5 on Gigabitethernet2/1/1
Dest 1::/64,
via FE80::20F:E2FF:FE23:82F5, cost 1, tag 0, A, 6 Sec
Dest 2::/64,
via FE80::20F:E2FF:FE23:82F5, cost 1, tag 0, A, 6 Sec
Peer FE80::20F:E2FF:FE00:100 on Gigabitethernet2/1/2
Dest 3::/64,
via FE80::20F:E2FF:FE00:100, cost 1, tag 0, A, 11 Sec
Dest 4::/64,
via FE80::20F:E2FF:FE00:100, cost 1, tag 0, A, 11 Sec
Dest 5::/64,
via FE80::20F:E2FF:FE00:100, cost 1, tag 0, A, 11 Sec
3. Configure Router B to filter incoming and outgoing routes:
[RouterB] acl ipv6 number 2000
[RouterB-acl6-basic-2000] rule deny source 3::/64
[RouterB-acl6-basic-2000] rule permit
[RouterB-acl6-basic-2000] quit