R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

307
[RouterB] ripng 1
[RouterB-ripng-1] filter-policy 2000 import
[RouterB-ripng-1] filter-policy 2000 export
# Display routing tables of Router B and Router A.
[RouterB] display ripng 1 route
Route Flags: A - Aging, S - Suppressed, G - Garbage-collect
----------------------------------------------------------------
Peer FE80::20F:E2FF:FE23:82F5 on Gigabitethernet2/1/1
Dest 1::/64,
via FE80::20F:E2FF:FE23:82F5, cost 1, tag 0, A, 2 Sec
Dest 2::/64,
via FE80::20F:E2FF:FE23:82F5, cost 1, tag 0, A, 2 Sec
Peer FE80::20F:E2FF:FE00:100 on Gigabitethernet2/1/2
Dest 4::/64,
via FE80::20F:E2FF:FE00:100, cost 1, tag 0, A, 5 Sec
Dest 5::/64,
via FE80::20F:E2FF:FE00:100, cost 1, tag 0, A, 5 Sec
[RouterA] display ripng 1 route
Route Flags: A - Aging, S - Suppressed, G - Garbage-collect
----------------------------------------------------------------
Peer FE80::20F:E2FF:FE00:1235 on Gigabitethernet2/1/1
Dest 1::/64,
via FE80::20F:E2FF:FE00:1235, cost 1, tag 0, A, 2 Sec
Dest 4::/64,
via FE80::20F:E2FF:FE00:1235, cost 2, tag 0, A, 2 Sec
Dest 5::/64,
via FE80::20F:E2FF:FE00:1235, cost 2, tag 0, A, 2 Sec
Configuring RIPng route redistribution
Network requirements
• Router B runs two RIPng processes. It communicates with Router A through RIPng 100 and with
Router C through RIPng 200.
• Configure route redistribution on Router B, allowing the two RIPng processes to redistribute routes
from each other. Set the default cost of redistributed routes from RIPng 200 to 3.
Figure 94 Network diagram