R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

ManualsBrandsHP ManualsNetwork HardwareHP HSR6804 Router Chassis

308

Configuration procedure

1. Configure IPv6 addresses for the interfaces. (Details not shown.)

2. Configure RIPng basic functions:

# Enable RIPng 100 on Router A.

<RouterA> system-view

[RouterA] ripng 100

[RouterA-ripng-100] quit

[RouterA] interface gigabitethernet 2/1/1

[RouterA-Gigabitethernet2/1/1] ripng 100 enable

[RouterA-Gigabitethernet2/1/1] quit

[RouterA] interface gigabitethernet 2/1/2

[RouterA-Gigabitethernet2/1/2] ripng 100 enable

# Enable RIPng 100 and RIPng 200 on Router B.

<RouterB> system-view

[RouterB] ripng 100

[RouterB-ripng-100] quit

[RouterB] interface gigabitethernet 2/1/2

[RouterB-Gigabitethernet2/1/2] ripng 100 enable

[RouterB-Gigabitethernet2/1/2] quit

[RouterB] ripng 200

[RouterB-ripng-200] quit

[RouterB] interface gigabitethernet 2/1/1

[RouterB-Gigabitethernet2/1/1] ripng 200 enable

# Enable RIPng 200 on Router C.

<RouterC> system-view

[RouterC] ripng 200

[RouterC] interface gigabitethernet 2/1/1

[RouterC-Gigabitethernet2/1/1] ripng 200 enable

[RouterC-Gigabitethernet2/1/1] quit

[RouterC] interface gigabitethernet 2/1/2

[RouterC-Gigabitethernet2/1/2] ripng 200 enable

[RouterC-Gigabitethernet2/1/2] quit

# Display the routing table of Router A.

[RouterA] display ipv6 routing-table

Routing Table :

Destinations : 6 Routes : 6

Destination: ::1/128 Protocol : Direct

NextHop : ::1 Preference: 0

Interface : InLoop0 Cost : 0

Destination: 1::/64 Protocol : Direct

NextHop : 1::1 Preference: 0

Interface : GE2/1/2 Cost : 0

Destination: 1::1/128 Protocol : Direct

NextHop : ::1 Preference: 0