R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

310
NextHop : FE80::200:BFF:FE01:1C02 Preference: 100
Interface : GE2/1/2 Cost : 4
Destination: FE80::/10 Protocol : Direct
NextHop : :: Preference: 0
Interface : NULL0 Cost : 0
Configuring RIPng IPsec policies
Network requirements
As shown in the following figure,
• Configure RIPng on the routers.
• Configure IPsec policies on the routers to authenticate and encrypt protocol packets.
Figure 95 Network diagram
Configuration procedure
1. Configure IPv6 addresses for interfaces. (Details not shown.)
2. Configure RIPng basic functions:
# Configure Router A.
<RouterA> system-view
[RouterA] ripng 1
[RouterA-ripng-1] quit
[RouterA] interface gigabitethernet 2/1/1
[RouterA-Gigabitethernet2/1/1] ripng 1 enable
[RouterA-Gigabitethernet2/1/1] quit
# Configure Router B.
<RouterB> system-view
[RouterB] ripng 1
[RouterB-ripng-1] quit
[RouterB] interface gigabitethernet 2/1/1
[RouterB-Gigabitethernet2/1/1] ripng 1 enable
[RouterB-Gigabitethernet2/1/1] quit
[RouterB] interface gigabitethernet 2/1/2
[RouterB-Gigabitethernet2/1/2] ripng 1 enable
[RouterB-Gigabitethernet2/1/2] quit
# Configure Router C.
<RouterC> system-view
[RouterC] ripng 1
[RouterC-ripng-1] quit
[RouterC] interface gigabitethernet 2/1/1
[RouterC-Gigabitethernet2/1/1] ripng 1 enable
[RouterC-Gigabitethernet2/1/1] quit