R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

328
Configuration prerequisites
Before applying an IPsec policy for OSPFv3, complete the following tasks:
• Create an IPsec proposal.
• Create an IPsec policy.
For more information about IPsec policy configuration, see Security Configuration Guide.
Configuration procedure
An IPsec policy used for OSPFv3 can only be in manual mode. For more information, see Security
Configuration Guide.
To apply an IPsec policy in an area:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter OSPFv3 view.
ospfv3 [ process-id ] N/A
3. Enter OSPFv3 area view.
area area-id N/A
4. Apply an IPsec policy in the
area.
enable ipsec-policy policy-name Not configured by default.
To apply an IPsec policy on an interface:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Apply an IPsec policy on the
interface.
ospfv3 ipsec-policy policy-name
[ instance instance-id ]
Not configured by default.
To apply an IPsec policy on a virtual link:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPFv3 view.
ospfv3 [ process-id ] N/A
3. Enter OSPFv3 area view.
area area-id N/A
4. Apply an IPsec policy on a
virtual link.
vlink-peer router-id [ hello seconds |
retransmit seconds | trans-delay seconds
| dead seconds | instance instance-id |
ipsec-policy policy-name ] *
Not configured by default.
Displaying and maintaining OSPFv3