R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

370
To configure IPv6 BGP route summarization:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 address
family view.
ipv6-family N/A
4. Configure manual
route summarization.
aggregate ipv6-address prefix-length [ as-set |
attribute-policy route-policy-name |
detail-suppressed | origin-policy route-policy-name
| suppress-policy route-policy-name ] *
Not configured by
default.
Advertising a default route to an IPv6 peer or peer group
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 address family
view.
ipv6-family N/A
4. Advertise a default route to
an IPv6 peer or peer
group.
peer { ipv6-group-name | ipv6-address }
default-route-advertise [ route-policy
route-policy-name ]
Not advertised by
default.
NOTE:
W
ith the peer default-route-advertise command executed, the local router advertises a default route with
itself as the next hop to the specified IPv6 peer or peer group, regardless of whether the default route is
available in the routing table.
Configuring outbound route filtering
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 address family view
or IPv6 BGP-VPN instance
view.
ipv6-family [ vpn-instance
vpn-instance-name ]
N/A
4. Configure the filtering of
outgoing routes.
filter-policy { acl6-number | ipv6-prefix
ipv6-prefix-name } export [ protocol
process-id ]
Not configured by default.