R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

374
Ste
p
Command Remarks
6. Advertise routes to an IPv6
peer or peer group with the
local router as the next hop.
peer { ipv6-group-name |
ipv6-address } next-hop-local
By default, IPv6 BGP specifies the
local router as the next hop for routes
sent to an IPv6 EBGP peer or peer
group, but does not change the next
hop for routes sent to an IPv6 IBGP
peer or peer group.
The IPv6 BGP-VPN instance view does
not support this command.
Configuring the MED attribute
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 address family view
or IPv6 BGP-VPN instance
view.
ipv6-family [ vpn-instance
vpn-instance-name ]
N/A
4. Configure a default MED
value.
default med med-value
Optional.
Defaults to 0.
5. Enable the comparison of
MED for routes from different
EBGP peers.
compare-different-as-med
Optional.
Not enabled by default.
The IPv6 BGP-VPN instance view
does not support this command.
6. Enable the comparison of
MED for routes from each AS.
bestroute compare-med
Optional.
Disabled by default.
The IPv6 BGP-VPN instance view
does not support this command.
7. Enable the comparison of
MED for routes from
confederation peers.
bestroute med-confederation
Optional.
Disabled by default.
The IPv6 BGP-VPN instance view
does not support this command.
Configuring the AS_PATH attribute
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 address family
view.
ipv6-family N/A