R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide
ii
Tuning and optimizing RIP networks ···························································································································· 30
Configuration prerequisites ·································································································································· 30
Configuring RIP timers ··········································································································································· 30
Configuring split horizon and poison reverse ···································································································· 30
Configuring the maximum number of ECMP routes ·························································································· 31
Enabling zero field check on incoming RIPv1 messages ·················································································· 31
Enabling source IP address check on incoming RIP updates ············································································ 32
Configuring RIPv2 message authentication ········································································································ 32
Specifying a RIP neighbor ···································································································································· 33
Configuring RIP-to-MIB binding ···························································································································· 33
Configuring the RIP packet sending rate ············································································································ 34
Configuring RIP FRR ······················································································································································· 34
Configuring BFD for RIP ················································································································································· 35
Enabling single-hop echo detection (for a directly connected RIP neighbor) ·················································· 35
Configuring single-hop echo detection (for a specific destination) ·································································· 36
Enabling bidirectional control detection ············································································································· 36
Displaying and maintaining RIP ··································································································································· 37
RIP configuration examples ··········································································································································· 37
Configuring RIP version ········································································································································ 37
Configuring RIP route redistribution ····················································································································· 39
Configuring an additional metric for a RIP interface ························································································· 41
Configuring RIP to advertise a summary route ··································································································· 43
Configuring RIP FRR ·············································································································································· 45
Configuring BFD for RIP (single-hop echo detection) ························································································· 46
Configure BFD for RIP (single-hop echo detection for a specified destination) ·············································· 49
Configuring BFD for RIP (bidirectional control detection) ················································································· 52
Troubleshooting RIP ························································································································································ 56
No RIP updates received ······································································································································ 56
Route oscillation occurred ···································································································································· 56
Configuring OSPF ······················································································································································ 58
Overview ········································································································································································· 58
OSPF packets ························································································································································· 58
LSA types ································································································································································ 59
OSPF area ······························································································································································ 59
Router types ···························································································································································· 62
Route types ····························································································································································· 62
Route calculation ··················································································································································· 63
OSPF network types ·············································································································································· 63
DR and BDR ··························································································································································· 63
Protocols and standards ······································································································································· 64
OSPF configuration task list ·········································································································································· 65
Enabling OSPF ······························································································································································· 66
Configuration prerequisites ·································································································································· 66
Configuration guidelines ······································································································································ 66
Configuration procedure ······································································································································ 67
Configuring OSPF areas ··············································································································································· 67
Configuration prerequisites ·································································································································· 68
Configuring a stub area ······································································································································· 68
Configuring an NSSA area ·································································································································· 68
Configuring a virtual link ······································································································································ 69
Configuring OSPF network types ································································································································· 70
Configuration prerequisites ·································································································································· 70
Configuring the broadcast network type for an interface ················································································· 70
Configuring the NBMA network type for an interface ······················································································ 71