R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

389
Task Command Remarks
Reset IPv6 BGP
connections.
reset bgp ipv6 { as-number | ipv4-address | ipv6-address |
all | external | group group-name | internal }
Available in user view.
Clearing IPv6 BGP information
Task Command Remarks
Clear dampened IPv6 BGP
routing information and
release suppressed routes.
reset bgp ipv6 dampening [ ipv6-address
prefix-length ]
Available in user view.
Clear IPv6 BGP route flap
information.
reset bgp ipv6 flap-info
[ ipv6-address/prefix-length | as-path-acl
as-path-acl-number | regexp as-path-regexp ]
reset bgp ipv6 peer-ipv6-address flap-info
Available in user view.
IPv6 BGP configuration examples
Some examples for IPv6 BGP configuration are similar to those of BGP. For more information, see
"Configuring BGP."
IPv6 BGP basic configuration
Network requirements
All routers in Figure 108 run IPv6 BGP. Between Router A and Router B is an EBGP connection. Router B,
Router C, and Router D are fully meshed through IBGP connections.
Figure 108 Network diagram
Configuration procedure
1. Configure IPv6 addresses for interfaces. (Details not shown.)
2. Configure IBGP connections:
# Configure Router B.
<RouterB> system-view
[RouterB] ipv6