R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

392
<RouterA> system-view
[RouterA] ipv6
[RouterA] bgp 100
[RouterA-bgp] router-id 1.1.1.1
[RouterA-bgp] ipv6-family
[RouterA-bgp-af-ipv6] peer 100::2 as-number 200
[RouterA-bgp-af-ipv6] network 1:: 64
# Configure Router B
<RouterB> system-view
[RouterB] ipv6
[RouterB] bgp 200
[RouterB-bgp] router-id 2.2.2.2
[RouterB-bgp] ipv6-family
[RouterB-bgp-af-ipv6] peer 100::1 as-number 100
[RouterB-bgp-af-ipv6] peer 101::1 as-number 200
[RouterB-bgp-af-ipv6] peer 101::1 next-hop-local
# Configure Router C.
<RouterC> system-view
[RouterC] ipv6
[RouterC] bgp 200
[RouterC-bgp] router-id 3.3.3.3
[RouterC-bgp] ipv6-family
[RouterC-bgp-af-ipv6] peer 101::2 as-number 200
[RouterC-bgp-af-ipv6] peer 102::2 as-number 200
# Configure Router D.
<RouterD> system-view
[RouterD] ipv6
[RouterD] bgp 200
[RouterD-bgp] router-id 4.4.4.4
[RouterD-bgp] ipv6-family
[RouterD-bgp-af-ipv6] peer 102::1 as-number 200
3. Configure route reflector:
# Configure Router C as a route reflector, and configure Router B and Router D as its clients.
[RouterC-bgp-af-ipv6] peer 101::2 reflect-client
[RouterC-bgp-af-ipv6] peer 102::2 reflect-client
4. Verify the configuration:
Execute the display bgp ipv6 routing-table command on Router B and Router D. Both have learned
the network 1::/64.
6PE configuration
Network requirements
As shown in the following figure:
• Routers PE 1 and PE 2 support 6PE.
• Routers CE 1 and CE 2 support IPv6.