R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

400
[RouterB-bgp-af-ipv6] quit
[RouterB-bgp] quit
6. Apply IPsec policies to EBGP peers:
# Configure Router C.
[RouterC] bgp 65009
[RouterC-bgp] ipv6-family
[RouterC-bgp-af-ipv6] peer ebgp ipsec-policy policy002
[RouterC-bgp-af-ipv6] quit
[RouterC-bgp] quit
# Configure Router B.
[RouterB] bgp 65008
[RouterB-bgp] ipv6-family
[RouterB-bgp-af-ipv6] peer ebgp ipsec-policy policy002
[RouterB-bgp-af-ipv6] quit
[RouterB-bgp] quit
7. Verify the configuration:
# Display detailed IPv6 BGP peer information.
[RouterB] display bgp ipv6 peer verbose
BGP Peer is 1::1, remote AS 65008,
Type: IBGP link
BGP version 4, remote router ID 1.1.1.1
BGP current state: Established, Up for 00h01m51s
BGP current event: RecvKeepalive
BGP last state: OpenConfirm
Port: Local – 1029 Remote - 179
Configured: Active Hold Time: 180 sec Keepalive Time: 60 sec
Received : Active Hold Time: 180 sec
Negotiated: Active Hold Time: 180 sec
Peer optional capabilities:
Peer support bgp multi-protocol extended
Peer support bgp route refresh capability
Address family IPv4 Unicast: advertised and received
Received: Total 0 messages, Update messages 0
Sent: Total 0 messages, Update messages 0
Maximum allowed prefix number: 4294967295
Threshold: 75%
Minimum time between advertisement runs is 30 seconds
Optional capabilities:
Route refresh capability has been enabled
ORF advertise capability based on prefix (type 64):
Local: both
Negotiated: send
Peer Preferred Value: 0
IPsec policy name: policy001, SPI :12345
Routing policy configured:
No routing policy is configured
BGP Peer is 3::2, remote AS 65009,