R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

29
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Configure the filtering of
received routes.
filter-policy { acl-number |
gateway ip-prefix-name | ip-prefix
ip-prefix-name [ gateway
ip-prefix-name ] } import
[ interface-type interface-number ]
By default, the filtering of received
routes is not configured.
The filter-policy import command
filters received routes. Filtered
routes are not installed into the
routing table or advertised to
neighbors.
4. Configure the filtering of
redistributed routes.
filter-policy { acl-number |
ip-prefix ip-prefix-name } export
[ protocol [ process-id ] |
interface-type interface-number ]
By default, the filtering of
redistributed routes is not
configured.
The filter-policy export command
filters redistributed routes,
including routes redistributed with
the import-route command.
Configuring a preference for RIP
If multiple IGPs find routes to the same destination, the route found by the IGP that has the highest priority
is selected as the optimal route. Perform this task to configure a preference for RIP. The smaller the
preference value, the higher the priority.
To configure a preference for RIP:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Configure a preference for
RIP.
preference [ route-policy
route-policy-name ] value
Optional.
The default setting is 100.
Configuring RIP route redistribution
Perform this task to configure RIP to redistribute routes from other routing protocols, including OSPF, IS-IS,
BGP, static, and direct routes. Only active routes can be redistributed. To display active routes, use the
display ip routing-table protocol command.
To configure RIP route redistribution:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A