R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

408
Task Remarks
Configuring an IPv6
policy
Creating an IPv6 node
Required.
Configuring match criteria for an IPv6 node
Defining the actions for an IPv6 node
Configuring IPv6
PBR
Configuring IPv6 local PBR
Required.
Perform
one of the tasks.
Configuring IPv6 interface PBR
Configuring an IPv6 policy
Creating an IPv6 node
Ste
p
Command
1. Enter system view.
system-view
2. Create an IPv6 policy or policy node
and enter IPv6 policy node view.
ipv6 policy-based-route policy-name [ deny | permit ] node
node-number
Configuring match criteria for an IPv6 node
An ACL match criterion uses the specified ACL to match packets if the match mode is configured as
permit. If the specified ACL does not exist or the match mode is configured as deny, no packet can match
the criterion.
To configure match criteria for an IPv6 node:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter IPv6 policy node view.
ipv6 policy-based-route policy-name [ deny |
permit ] node node-number
N/A
3. Configure an ACL match
criterion.
if-match acl6 acl-number Optional.
4. Configure an IPv6 packet
length match criterion.
if-match packet-length min-len max-len Optional.
Defining the actions for an IPv6 node
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter IPv6 policy node view.
ipv6 policy-based-route policy-name
[ deny | permit ] node node-number
Not created by default.