R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

429

Applying a routing policy to IPv6 route redistribution

Network requirements

• In Figure 117, enable RIPng on Router A and Router B.

• Configure three static routes on Router A

• On Router A, enable static route redistribution into RIPng and apply a routing policy to permit routes

20::/32 and 40::/32 and deny route 30::/32.

Figure 117 Network diagram

Configuration procedure

1. Configure Router A:

# Configure IPv6 addresses for interfaces GigabitEthernet 2/1/1 and GigabitEthernet 2/1/2.

<RouterA> system-view

[RouterA] ipv6

[RouterA] interface gigabitethernet 2/1/1

[RouterA-GigabitEthernet2/1/1] ipv6 address 10::1 32

[RouterA-GigabitEthernet2/1/1] quit

[RouterA] interface gigabitethernet 2/1/2

[RouterA-GigabitEthernet2/1/2] ipv6 address 11::1 32

[RouterA-GigabitEthernet2/1/2] quit

# Enable RIPng on GigabitEthernet 2/1/1.

[RouterA] interface gigabitethernet 2/1/1

[RouterA-GigabitEthernet2/1/1] ripng 1 enable

[RouterA-GigabitEthernet2/1/1] quit

# Configure three static routes with next hop 11::2, and make sure that the static routes are active.

[RouterA] ipv6 route-static 20:: 32 11::2

[RouterA] ipv6 route-static 30:: 32 11::2

[RouterA] ipv6 route-static 40:: 32 11::2

# Configure a routing policy.

[RouterA] ip ipv6-prefix a index 10 permit 30:: 32

[RouterA] route-policy static2ripng deny node 0

[RouterA-route-policy] if-match ipv6 address prefix-list a

[RouterA-route-policy] quit

[RouterA] route-policy static2ripng permit node 10

[RouterA-route-policy] quit

# Enable RIPng and apply routing policy static2ripng to filter redistributed static routes on Router

[RouterA] ripng

[RouterA-ripng-1] import-route static route-policy static2ripng