R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

436

Figure 119 Network diagram

Configuration procedure

# Configure ACL 2000.

<RouterA> system-view

[RouterA] acl number 2000

[RouterA-acl-basic-2000] rule 0 permit source any

[RouterA-acl-basic-2000] quit

# Define a match criterion for the class a to match ACL 2000.

[RouterA] traffic classifier a

[RouterA-classifier-a] if-match acl 2000

[RouterA-classifier-a] quit

# Configure the action of redirecting traffic to GigabitEthernet 2/0/3 for the behavior a.

[RouterA] traffic behavior a

[RouterA-behavior-a] redirect interface gigabitethernet2/0/3

[RouterA-behavior-a] quit

# Associate the class a with the behavior a in the QoS policy a.

[RouterA] qos policy a

[RouterA-qospolicy-a] classifier a behavior a

[RouterA-qospolicy-a] quit

# Apply the QoS policy a to the inbound direction of GigabitEthernet 2/0/1.

[RouterA] interface gigabitethernet 2/0/1

[RouterA-GigabitEthernet2/0/1] qos apply policy a inbound

Verifying the configuration

After completing the configuration, verify that when Router A receives packets with destination IP address

201.1.1.2, it forwards the packets to Router C instead of Router B.

IPv6 QoS policy routing configuration example

Network requirements

As shown in 0, configure a QoS policy, so that all packets received on GigabitEthernet 2/0/1 of Router

A are forwarded out of GigabitEthernet 2/0/3 of Router A.