R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

35
Configuration procedure
To configure RIP FRR:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure the source address
of echo packets.
bfd echo-source-ip ip-address Not configured by default.
3. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
4. Enable RIP FRR and reference
a routing policy to designate
a backup next hop.
fast-reroute route-policy
route-policy-name
Disabled by default.
Configuring BFD for RIP
BFD for RIP provides the following link detection modes:
• Single-hop echo detection mode for a directly-connected RIP neighbors. In this mode, a BFD session
is established only when the neighbor has route information to send.
• Single-hop echo detection mode for a specific destination. In this mode, a BFD session is
established to the specified RIP neighbor only when the RIP-enabled interface is up.
• Bidirectional control detection mode for an indirectly-connected neighbor. In this mode, a BFD
session is established only when both ends have routes to send and BFD is enabled on the receiving
interface.
For more information about BFD, see High Availability Configuration Guide.
Enabling single-hop echo detection (for a directly connected
RIP neighbor)
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure the source IP
address of BFD echo packets.
bfd echo-source-ip ip-address
By default, no source IP address is
configured for BFD echo packets.
3. Enter interface view.
interface interface-type
interface-number
N/A
4. Enable BFD for RIP.
rip bfd enable
By default, BFD for RIP is disabled.
The rip bfd enable command and
the rip bfd enable destination
command are mutually exclusive
and cannot be configured on a
device at the same time.