R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

37
Displaying and maintaining RIP
Task Command Remarks
Display RIP current status and
configuration information.
display rip [ process-id |
vpn-instance vpn-instance-name ]
[ | { begin | exclude | include }
regular-expression ]
Available in any view.
Display all active routes in RIP
database.
display rip process-id database [ |
{ begin | exclude | include }
regular-expression ]
Available in any view.
Display RIP interface information.
display rip process-id interface
[ interface-type interface-number ]
[ | { begin | exclude | include }
regular-expression ]
Available in any view.
Display routing information about
a specified RIP process.
display rip process-id route
[ ip-address { mask | mask-length }
| peer ip-address | statistics ] [ |
{ begin | exclude | include }
regular-expression ]
Available in any view.
Reset a RIP process. reset rip process-id process Available in user view.
Clear the statistics of a RIP process. reset rip process-id statistics Available in user view.
RIP configuration examples
Configuring RIP version
Network requirements
As shown in Figure 7, enable RIPv2 on all interfaces on Router A and Router B.
Figure 7 Network diagram
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown.)
2. Configure basic RIP:
# Configure Router A.
<RouterA> system-view
[RouterA] rip
[RouterA-rip-1] network 1.0.0.0