R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

41
11.1.1.0/24 RIP 100 1 12.3.1.1 GE2/1/1
12.3.1.0/24 Direct 0 0 12.3.1.2 GE2/1/1
12.3.1.2/32 Direct 0 0 127.0.0.1 InLoop0
16.4.1.0/24 Direct 0 0 16.4.1.1 GE2/1/2
16.4.1.1/32 Direct 0 0 127.0.0.1 InLoop0
127.0.0.0/8 Direct 0 0 127.0.0.1 InLoop0
127.0.0.1/32 Direct 0 0 127.0.0.1 InLoop0
Configuring an additional metric for a RIP interface
Network requirements
As shown in Figure 9, run RIPv2 on all the interfaces of Router A, Router B, Router C, Router D, and Router
E.
Router A has two links to Router D. The link from Router B to Router D is more stable than that from Router
C to Router D. Configure an additional metric for RIP routes received from GigabitEthernet 2/1/2 on
Router A so Router A prefers route 1.1.5.0/24 learned from Router B.
Figure 9 Network diagram
Configuration procedure
1. Configure IP addresses for the interfaces. (Details not shown.)
2. Configure basic RIP:
# Configure Router A.
<RouterA> system-view
[RouterA] rip
[RouterA-rip-1] network 1.0.0.0
[RouterA-rip-1] version 2
[RouterA-rip-1] undo summary
[RouterA-rip-1] quit
# Configure Router B.
<RouterB> system-view
[RouterB] rip
[RouterB-rip-1] network 1.0.0.0
[RouterB-rip-1] version 2
[RouterB-rip-1] undo summary
# Configure Router C.
<RouterC> system-view
[RouterB] rip
Router B
Router C
Router A
Router D
Router E
GE2/1/1
1.1.1.1/24
GE2/1/1
1.1.1.2/24
GE2/1/2
1.1.2.1/24
GE2/1/1
1.1.2.2/24
GE2/1/2
1.1.3.1/24
GE2/1/2
1.1.4.1/24
GE2/1/2
1.1.3.2/24
GE2/1/1
1.1.4.2/24
GE2/1/3
1.1.5.1/24
GE2/1/1
1.1.5.2/24