R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

Figure 14 Network diagram

Configuration procedure

1. Configure IP addresses for interfaces. (Details not shown.)

2. Configure basic RIP basic and enable static route redistribution into RIP so Router A and Router C

have routes to send to each other:

# Configure Router A.

<RouterA> system-view

[RouterA] rip 1

[RouterA-rip-1] network 192.168.1.0

[RouterA-rip-1] peer 192.168.2.2

[RouterA-rip-1] undo validate-source-address

[RouterA-rip-1] import-route static

[RouterA-rip-1] quit

[RouterA] interface GigabitEthernet 2/1/2

[RouterA-GigabitEthernet2/1/2] rip bfd enable

[RouterA-GigabitEthernet2/1/2] quit

[RouterA] rip 2

[RouterA-rip-2] network 192.168.3.0

[RouterA-rip-2] quit

# Configure Router C.

<RouterC> system-view

[RouterC] rip 1

[RouterC-rip-1] network 192.168.2.0

[RouterC-rip-1] network 192.168.4.0

[RouterC-rip-1] peer 192.168.1.1

[RouterC-rip-1] undo validate-source-address

[RouterC-rip-1] import-route static

[RouterC-rip-1] quit

[RouterC] interface GigabitEthernet 2/1/1

[RouterC-GigabitEthernet2/1/1] rip bfd enable

[RouterC-GigabitEthernet2/1/1] quit

# Configure Router D.

<RouterD> system-view