R3303-HP HSR6800 Routers Layer 3 - IP Routing Configuration Guide

66
Task Remarks
Adding the interface MTU into DD packets Optional.
Configuring the maximum number of external LSAs in LSDB Optional.
Enabling compatibility with RFC 1583 Optional.
Logging neighbor state changes Optional .
Configuring OSPF network management Optional.
Enabling message logging Optional.
Enabling the advertisement and reception of opaque LSAs Optional.
Configuring OSPF to give priority to receiving and processing
hello packets
Optional.
Configuring the LSU transmit rate Optional.
Enabling OSPF ISPF Optional.
Configuring OSPF FRR Optional.
Configuring OSPF GR
Configuring the OSPF GR restarter Optional.
Configuring the OSPF GR helper Optional.
Triggering OSPF GR Optional.
Configuring OSPF NSR Optional.
Configuring BFD for OSPF Optional.
Enabling OSPF
Enable OSPF before you perform other OSPF configuration tasks.
Configuration prerequisites
Configure the link layer protocol and IP addresses for interfaces so that neighboring nodes can
communicate with each other.
Configuration guidelines
Complete the following tasks to enable an interface to run an OSPF process in an area:
• Enable the OSPF process
• Create the area for the OSPF process
• Add the network segment where the interface resides to the area. The OSPF process advertises the
direct route of the interface.
• Specify a router ID, the unique identifier of the router in the AS.
Following is additional information about router IDs:
• You can specify a router ID when you create an OSPF process. Any two routers in an AS must have
different router IDs. A typical practice is to specify the IP address of an interface as the router ID.