R3303-HP HSR6800 Routers Layer 3 - IP Services Configuration Guide

210
AFT configuration task list
IPv4-to-IPv6 static mappings configuration task list
Task Remarks
Enabling AFT Required.
Configuring an IPv4-to-IPv6 static mapping Required.
When communication is initiated by an IPv6 host
Task Remarks
Enabling AFT Required
Configuring an IVI prefix
Required.
Perform either one.
Configuring a 6to4 AFT policy
When communication is initiated by an IPv4 host
Task Remarks
Enabling AFT Required.
Configuring an IVI prefix Required.
Configuring 4to6 AFT policies Required.
Configuration prerequisites
Before you configure AFT:
1. Enable IPv6 on the AFT. For more information, see "Configuring IPv6 basics."
2. Configure an IPv4 or IPv6 address as required on the interface which connects to an IPv4 or IPv6
network and on which AFT is to be enabled.
Enabling AFT
Enable AFT on both the interface connected to the IPv4 network and the interface connected to the IPv6
network.
Do not configure AFT policies and NAT-PT mapping policies on the same device.
To enable AFT: