R3303-HP HSR6800 Routers Layer 3 - IP Services Configuration Guide

299
Creating a VAM client
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a VAM client and
enter its view.
vam client name client-name No client is created by default.
Setting the VAM protocol packet retransmission interval
If a client sends a VAM protocol packet to the server but receives no response in a specific period of time,
it retransmits the packet. A VAM protocol packet can be a connection request, negotiation
acknowledgement, registration request, or authentication request.
The maximum number of attempts to retransmit a VAM protocol packet is always 3. You cannot change
this value.
To set the interval for retransmitting a VAM protocol packet:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter VAM client view.
vam client name client-name N/A
3. Set the VAM protocol packet
retransmission interval.
resend interval time-interval
Optional.
5 seconds by default.
Specifying the primary VAM server
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter VAM client view.
vam client name client-name N/A
3. Specify the primary VAM
server.
server primary ip-address
ip-address [ port port-number ]
Not specified by default.
Specifying the secondary VAM server
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter VAM client view.
vam client name client-name N/A
3. Specify the secondary VAM
server.
server secondary ip-address
ip-address [ port port-number]
Not specified by default.