R3303-HP HSR6800 Routers Layer 3 - IP Services Configuration Guide

311
[Hub2-Tunnel1] ip address 10.0.1.2 255.255.255.0
[Hub2-Tunnel1] source gigabitethernet 3/0/1
[Hub2-Tunnel1] ospf network-type broadcast
[Hub2-Tunnel1] ipsec profile vamp
[Hub2-Tunnel1] quit
# Configure tunnel interface Tunnel2 for VPN 2. Tunnel 2 uses GRE for encapsulation.
[Hub2] interface tunnel 2
[Hub2-Tunnel2] tunnel-protocol dvpn gre
[Hub2-Tunnel2] vam client dvpn2hub2
[Hub2-Tunnel2] ip address 10.0.2.2 255.255.255.0
[Hub2-Tunnel2] source gigabitethernet 3/0/1
[Hub2-Tunnel2] ospf network-type broadcast
[Hub2-Tunnel2] ipsec profile vamp
[Hub2-Tunnel2] quit
5. Configure OSPF:
# Configure OSPF for the public network.
[Hub2] ospf 100
[Hub2-ospf-100] area 0
[Hub2-ospf-100-area-0.0.0.0] network 192.168.1.2 0.0.0.255
[Hub2-ospf-100-area-0.0.0.0] quit
# Configure OSPF for the private networks.
[Hub2] ospf 200
[Hub2-ospf-200] area 0
[Hub2-ospf-200-area-0.0.0.0] network 10.0.1.2 0.0.0.255
[Hub2-ospf-200-area-0.0.0.0] quit
[Hub2] ospf 300
[Hub2-ospf-300] area 0
[Hub2-ospf-300-area-0.0.0.0] network 10.0.2.2 0.0.0.255
Configuring Spoke 1
1. Configure IP addresses for the interfaces. (Details not shown.)
2. Configure the VAM client:
<Spoke1> system-view
# Create a VAM client named dvpn1spoke1 for VPN 1.
[Spoke1] vam client name dvpn1spoke1
[Spoke1-vam-client-name-dvpn1spoke1] vpn 1
# Specify the IP addresses of the VAM servers and set the pre-shared key.
[Spoke1-vam-client-name-dvpn1spoke1] server primary ip-address 192.168.1.22
[Spoke1-vam-client-name-dvpn1spoke1] server secondary ip-address 192.168.1.33
[Spoke1-vam-client-name-dvpn1spoke1] pre-shared-key simple 123
# Create a local user named dvpn1spoke1, setting the password as dvpn1spoke1.
[Spoke1-vam-client-name-dvpn1spoke1] user dvpn1spoke1 password simple dvpn1spoke1
[Spoke1-vam-client-name-dvpn1spoke1] client enable
[Spoke1-vam-client-name-dvpn1spoke1] quit
3. Configure the IPsec profile:
# Configure the IPsec transform set.